Tips to Replace the Water Pump in Car

The car water pump is very important to your car’s cooling system. This will ensure the proper flow of the coolant through the system. You should replace the pumps pulley bearing when it is shot or the gasket of the pump when it leaks. If you want to replace the pump, you will find that it is quite easy to do so that you can save your money and time to the shop for repairing it.

The first thing that you have to do is to find a water pump that is suitable for your car. Then, you should turn off the engine of your car. Make sure that the engine has cooled down completely when you are about to start replacing the pump. Then you should locate the car battery. In this case, make sure that you disconnect the battery’s ground.

The second thing that you have to do is to set up a drain pan beneath the engine. Then, you should drain the contents of the cooling system. In this case, you should make sure that the cooling compartment is perfectly drained.

The third thing that you have to do is to find the alternator mounting brackets. Then you should loosen them to remove the drive belts. To unfasten them, you can use sockets with the appropriate size and lift them away. Then, you should clear any clutter or accessories out of the water pump’s path. Then, you should access it by removing the pulley, fan and fan shroud of the engine.

After that, you should disconnect the hoses of the water pump. To do this, you can use a socket or wrench. You should loosen the screws and remove the water pump from the engine. Place it in away form your work area. Look at the engine block and perform an inspection to it. You should clean it up if it needs cleaning by using a rag.

The fifth thing that you should do is to change the gaskets of the water pump if you find that they are damaged or broken. Then, you should line up the new water pump and place it in the old previous place of the old pump. In doing it, you should consult the manual to double-check so that you can do the correct thing. Then, you need to bolt the water pump at a certain pressure properly.

The next thing that you should do is to reconnect the water pump hoses. You should also put anything else that you have removed back. In this case, you have to make sure that the belts are properly adjusted to the car’s tension specifications.

The last thing that you should do is to refill the car cooling system. In this case, you can upgrade to a better coolant product or antifreeze. Then, you should plug the battery back and start your car. Make sure that you perform an inspection in order to ensure you that everything is running well.

Related Posts

  1. How to Replace Your Car Radiator
  2. How to Replace the Fuel Pump On a Jeep Cherokee
  3. How to Replace the Starter on a Jeep Cherokee
  4. How to Recognize Signs of Overheating Problems to Your Car and What to Do If Your Car Overheats
  5. Car Battery Care Tips – Battery Care and Maintenance Tips

Leave a Reply

You must be logged in to post a comment.